Technical Specifications; Disposal And Recycling - stayer SC2600W Instructions D'emploi

tool at an outside location, only use extensible cables for
outside use that are marked for this purpose.
19 Be alert. Look at what you are doing, use common sense
and do not work with the machine when you are tired.
20 Check damaged parts. Before using a tool again, it
should be carefully checked so as to determine that it
will operate suitably and be apt for the operation which
has been assigned to it. Examine alignment, fixing
and tightening of mobile and fixed parts, breakage of
parts, mounting, and other conditions that may affect
its operation. A damaged guard or other part should be
suitably repaired or replaced by an authorized technical
service unless anything else is stated in the instructions
manual. Have faulty switches replaced by an authorized
technical service. Do not use the tool if the switch does
not switch on or switch off.
21 Warning: The use of any accessories or supplements
other than one recommended in this instructions manual
may generate personal damages.
22 Have the tool repaired by qualified personnel. This
electrical tool complies with the appropriate safety
requirements. Repairs should be carried out by qualified
personnel only using original spareparts; otherwise, a
considerable risk could be generated for the user.

TECHNICAL SPECIFICATIONS

18.
INoise Vibration lnformation
Noise determined according to EN 62841-1.
Use protection!
The vibration emission level given in this information
sheet
has been measured in accordance with a standardised test
given in EN 62841-1 and may be used to compare one tool
with another. lt may be used for a preliminary assessment of
exposure.
The declared vibration emission level represents the main
applications of the tool. However if the tool is used for different
applications,with different accessories or poorly maintained,
the vibration emission may differ.
This may significantly increase the exposure leveloverthe
totalworking period.
An estimation of the levelof exposure to vibration should also
take into account the times when the tool is switched
off or when it is running but not actually doing the job.
This may significantly reduce theexposure level over the total
working period.
ldentify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and
the accessories,keepthe hands warm, organisation of work
pattems.
The values givenarevalid for nominalvoltages [U]230/240
V-50/60 Hz - 110/120 V - 60Hz. For lower voltage and models
for specific countries, these values can vary.

DISPOSAL AND RECYCLING

19.
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste!
According the European Guideline 2012/19/UE
for Waste Electrical and Electronic Equipment
and its implementation into national right,power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
correct manner.
Subject to change wlthout notlce.
ENGLISH
20
20