Hagen GLO T5HO Mode D'emploi page 6

Installation using the
Aquarium Mounting Brackets
(1) Place the light unit on a flat solid surface, use tweezers to open
the screw cover (Fig. 1) (B) on the bracket cover (Fig. 1) (A).
(2) Unscrew the screw that retains the aquarium mounting bracket
cover (using a Phillips #3 screw driver), then remove the bracket
cover (Fig. 2).
(3) Loosen and open the clamp at the bottom of each attached
aquarium mounting bracket such that they can be securely
placed on each end of the aquarium (Fig. 3). Hand tighten the
inner clamp knob so that the aquarium mounting brackets are
securely fastened to each end of the aquarium (Fig. 3) (C).
(4) Carefully rotate the light unit (only after the aquarium mounting
brackets are securely fastened to the aquarium) upwards and
towards yourself (approximate 120 degree rotation) until no
further rotation is possible (Fig. 4).
This unit has been designed to allow bulb installation and
replacement after it has been mounted to your aquarium. To
install fluorescent tube(s) after the light unit has been mounted
using the integrated aquarium mounting brackets, please rotate
the unit as described above and follow the "Fluorescent Tube
Installation" instructions.
(5) To complete the installation, rotate the light unit so that the
fluorescent bulb(s) faces the water surface. Place the aquarium
mounting bracket cover on the mounting bracket and securely
tighten it in position using a Phillips #3 screw driver (Fig. 5).
Replace screw cover.
INSTALLATION
(6) Plug in the light unit.
Replacing the Fluorescent Tube(s)
(1) Unplug the light unit from the power supply.
(2) Rotate the light unit as described within the "Installation using
the Aquarium Mounting Brackets" Instruction.
(3) Refer to the instructions entitled "Fluorescent Tube Installation"
when replacing fluorescent tubes.
GLO T5 HO Linear Fluorescent Lighting Systems are
suitable for installation on the following aquarium lengths
only:
• 24"(61cm) single and double GLO T5 HO Linear Fluorescent
Lighting System: Aquariums 23"(58cm) to 40"(102cm).
• 36"(91cm) single and double GLO T5 HO Linear Fluorescent
Lighting System: Aquariums 35"(89cm) to 52"(132cm).
• 48"(122cm) single and double GLO T5 HO Linear Fluorescent
Lighting System: Aquariums 46"(117cm) to 64"(163cm).
MAINTENANCE:
WARNING: Always unplug all electrical aquarium accessories
when placing hands, etc., in water. The electrical supply cords
of this lighting system cannot be replaced. This fluorescent
lighting system has no user serviceable parts.
CLEANING THE UNIT:
(1) Do not place the GLO T5 HO High Output Linear Fluorescent Lighting
System near aquarium filter outputs or expose it to water spray or
humidity. Do not submerge in water.
(2) No special maintenance is required for the GLO T5 HO High Output
Linear Fluorescent Lighting System, other than periodic cleaning with
a cloth (never use harsh chemical products or detergents). To remove
calcareous deposits, it is recommended to use a mild acid such as
vinegar, followed by a thorough wipe down with a damp cloth to
remove any residues.
(3) It is strongly recommended to always follow all the precautions
and procedures outlined in both the Important Safe Guards and
Installation Instructions.