Specific Instructions For The Use Of Model Ac 230V - Sprintus Tortuga Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 50
it from the control panel.
If necessary, charge the battery (see the relative
section).
7.14 SPECIFIC INSTRUCTIONS FOR THE USE
OF MODEL AC 230V
The AC 230V machine may be turned on only if
the voltage indicated on the tag corresponds with
the available voltage and that the electrical outlet
is grounded (earthed).
Do not damage the feed cable; do not crush or
pull on it.
Do not run over the feed cable with the machine.
The cable could wind up in moving parts causing
a short circuit.
N
(
) ATTENTION - The AC 230V machine has
parts, which are connected to the current;
contact with these could cause grave injuries
or even death.
- Before executing any type of operation on the
machine always disconnect it from the electrical
source.
- Never touch electric cables that are defective or
worn.
- Before gaining access to the electrical system it is
always necessary to disconnect the machine from
the electrical source.
- In the case of defective, damaged, or cracked
electric cables, replace immediately with authentic
replacement parts.
- The network of connections must be protected
from water spray.
- The patch cord for the connection of the
machine to the mains power must conforms
to current safety rules.
- The electrical system to which the machine is
connected must be equipped with a cutout box.
- It is absolutely forbidden to use the machine in
proximity to swimming pools or stretches of water.
N
(
) EMERGENCY SITUATIONS
In case of emergency:
- Immediately disconnect the machine from
the power mains.
- Immediately apply proper first-aid.
If an accident should occur the machine must not
be put into operation until a technician authorized
by the manufacturer has examined it.
7 - OPERATING INFORMATIONS
45

Publicité

Table des Matières
loading

Table des Matières