Brush Assembly / Disassembly; Machine Transport - Sprintus Tortuga Mode D'emploi

7.3 BRUSH ASSEMBLY / DISASSEMBLY

!
( ) Never use the machine if the brush or the pad
holder with abrasive pad is not perfectly installed.
Assembly:
Place the brush on the floor;
lift the squeegee using the lifting/lowering lever (
Photo 2 - B )
Holding the handlebar ( Photo 1 - A ) push it down-
ward in order to lift the front part of the machine
by rotating it on the rear wheels;
move the machine and place it over the brush, tak-
ing care that the coupling flange on the brush is
under the metal coupling of the machine ( Photo
20 ).
Switch on the machine using the key switch ( Photo
8 - A ) or the general ON/OFF switch on the control
panel ( Photo 5 - A ).
Select the brush rotation with the brush switch (
Photo 5 - D ; Photo 7 - C ) and start the brush
rotation pulling the control lever ( Photo 2 - A ): the
brush will couple automatically.
To assemble the pad holder follow the same pro-
cedure.
!
( ) Do not allow the length of the rows of brushes
to become lower than 1 cm.
!
( ) Do not allow the thickness of the abrasive
disks to become less than 1 cm.
Working with excessively worn brushes or exces-
sively thin abrasive disks may damage the machine
and the floor.
Regularly check the wear on these parts before
starting to work.
Disassembly or replacement:
Lift the squeegee using the lifting/lowering lever (
Photo 2 - B )
Holding the handlebar ( Photo 1 - A ) push it down-
ward in order to lift the front part of the machine
by rotating it on the rear wheels;
Select the brush rotation with the brush switch (
Photo 5 - D ; Photo 7 - C ) and start the brush ro-
tation pulling the control lever ( Photo 2 - A ) while
holding the machine lifted up; release the control
lever to stop the rotation: the brush will unhook
automatically.
To disassemble the pad holder follow the same
procedure.

7.4 MACHINE TRANSPORT

To transport the machine while not working, pro-
ceed as follows:
7 - OPERATING INFORMATIONS
Switch OFF the machine using the key switch (
Photo 8 - A ) or the general ON/OFF switch on the
control panel ( Photo 5 - A ).
lift the squeegee using the lifting/lowering lever (
Photo 2 - B ).
Holding the handlebar ( Photo 1 - A ) push it down-
ward in order to lift the front part of the machine
by rotating it on the rear wheels;
While holding the machine in this position, push
it to the new working area or to the parking area.
Photo 20
Photo 21
39