Num'axes Canicom 800 Guide D'utilisation page 24

indicator light on the collar will flash in green indicating that the collar is on.
- Deactivate: Approach the area where the On/Off switch magnet is located in the remote control
until coming in contact on red mark located on the collar, hold for 1 second (ref. Diagram 7 or 8) .
The indicator light on the collar will flash from green to red and then off: the collar is off.
If you have several collars, renew the same procedure for each one.
To increase the battery life of the collar, we recommend you to deactivate the unit if you are not using
it for a long period.
Activate/deactivate a
receiver collar
with a CANICOM 800 remote
control
Diagram 7
Approach until coming in
contact those 2 areas
during 1 second
Coding of the remote control and receiver collar
The coding of the remote control with the receiver collar enables the two units to work together. You can
add additional collars at any time.
IMPORTANT : before beginning the coding (first use of the receiver or re-coding), make sure no other
person is using his CANICOM 800/CANICOM 1500 or other products from the NUM'AXES range close
by. Your receiver could accidentally record the code of his remote control. If that occurs, re-code the
remote control with the receiver collar.
For CANICOM 800 :
Collar A = black collar – Collar B = yellow collar
For CANICOM 1500 :
Collar 1 = black collar – Collar 2 = yellow collar – Collar 3 = orange collar – Collar 4 = blue collar
Coding procedure for the first use :
Warning : If you have several collars, you have to code them one at a time.
1. Activate the remote control: Press the On/Off red button
for 1 second.
Gb - 24
Activate/deactivate a
receiver collar
with a CANICOM 1500
remote control
Diagram 8
Approach until coming in
contact those 2 areas
during 1 second
located on the side of the remote control