Mounting Yoke / Joint - WALTERSCHEID SW40 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10. Clamp the profile tube (1) tightly in the
clamping profiles (3) using the hand pump
(2).
11. Drive out the clamping pin (4) carefully.
12. Move the mounting carriage (5) (see Chap-
ter 6.3) to the back until the profile tube is
completely pulled out of the inboard yoke
(6).
13. Release the profile tube (1) in the clamping
profiles (2).
14. Hold the joint (3) with one hand.
15. Undo the clamping lever screws (4).
16. Keep turning the threaded rod (5) until the
counter bearings (6) and the clamping lever
(7) release the inboard yoke (8).
17. Remove the yoke or the joint from the spe-
cial tool.
8.2

Mounting yoke / joint

1. Insert the inboard yoke (1) into the counter
bearings (2) so that the bore hole (3) of the
grooved yoke faces upwards.
2. Keep turning the threaded rod (4) until the
counter bearings (2) for the guidance of the
inboard yoke are just against the area of the
guard bearing running groove (do not clamp
tight).
3. Support the joint (5) using the support (6).
Fig. 27
Fig. 28
Fig. 29
41

Publicité

Table des Matières
loading

Table des Matières