Plebani Imola Instructions D'assemblage Et Mode D'emploi page 13

ASSEMBLING:
After taken walker out from the packaging, place it upside down on the ground (the base of the
walker up) and put the wheels into the holes (Fig. 1) WELL to the end. MAKE SURE THAT ALL
WHEELS ARE WELL FIXED! Turn walker in a horizontal position with the wheels on the ground
and pull the tray upward (Fig. 2).
To fix the seat to the walker (Fig. 3), insert the straps into holes of the tray (Fig. 4) pulling straps
(Fig. 5) until buckles are totally out (Fig. 6). Repeat the same operation for each strap. Insert the
side pins into holes (Fig. 7) and slide them along the length of the slot until locked (Fig. 8). Then
insert the pins of the front into slots (Fig. 9).
MAKE SURE THAT SEAT IS CORRECTLY INSTALLED!
To fix toy on tray, first insert rear tabs (those close to the seat) (Fig. 10), turn toy downward (Fig.
11) until front pins are totally out so to complete fixing. Make sure that toy is properly and securely
MAKE SURE THAT
fixed to tray. Now your walker is assembled and ready for use (Fig. 12).
SEAT IS CORRECTLY INSTALLED!
To fix toy on tray, first insert rear tabs (those close to the seat) (Fig. 10), turn toy
downward (Fig. 11) until front pins are totally out so to complete fixing. Make sure that toy
is properly and securely fixed to tray. Now your walker is assembled and ready for use
(Fig. 12).
ELECTRONIC TABLET:
WARNING!: This tablet teaching, according to EN 71: 2011 (CЄ) is MUSIC and require
batteries for operation. Batteries NOT INCLUDED. Use number 2 batteries of "AA" 1.5 V.
To remove toy and insert batteries, press pushing up the front pins under tray (Fig. 13),
turn the tablet up and remove it. To introduce (or, in future, replace) batteries, open the
cap placed under toy by unscrewing the screw (Fig. 14). After inserting/replacing
batteries, close the cover and screw it, then placing it back on the board (Fig. 10 and 11).
REGULATIONS:
Our walker can be adjusted to three different heights (Fig. 15) according to the age and
height of your child; remember that the baby, when sitting, must always keep their feet on
the ground. To activate this feature, you must act on self-locking security button placed
under the dinner tray (Fig. 16). To lower it, turn and keep turning the button (Fig. 17),
pressing it to lower walker (Fig. 18). Choose the height or put the walker in the closed
position. To raise it, pull tray upwards.
WARNING: DO NOT MAKE ANY ADJUSTMENT OPERATIONS WITH BABY INSIDE
WALKER.