Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
AC Power
Power Linking
AC Plug
Replacing the
Fuse
DMX Linking
DMX Connection
Art-Net™
Connection
Kling-Net
Connection
Master/Slave
Connection
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
You can link up to 4 Nexus™ 4x4 products at 120 VAC or 8 at 230 VAC.
Never exceed this number. Power linking cords can be purchased
separately.
Connection
AC Live
AC Neutral
AC Ground
1.
Disconnect this product from power.
2.
Using a flat-head screwdriver, unscrew the fuse holder cap from
the housing.
3.
Remove blown fuse and replace with a good fuse of the same type
and rating.
4.
Screw the fuse holder cap back in place and reconnect power.
The Nexus™ 4x4 will work with a DMX controller using a regular DMX
serial connection. A DMX Primer is available from www.chauvetpro.com.
The Nexus™ 4x4 uses a regular DMX data for its DMX personalities: 3, 5,
9, 48 and 53. See the User Manual to connect and configure for DMX
operation.
Art-Net™ is an Ethernet protocol that uses TCP/IP to transfer large
amounts of DMX512 data over a network. Art-Net™ uses the Neutrik®
etherCON® RJ 45 connection. An Art-Net™ Primer is available from
www.chauvetpro.com. Art-Net™ is Designed by and Copyright Artistic
Licence Holdings Ltd.
Kling-Net is a network protocol to allow auto configuration of display
devices over ethernet. Kling-Net uses the Neutrik® etherCON®
connection. Refer to the ArKaos MediaMaster™ software manual for
detailed instructions on installing and programming this product using this
protocol.
The Nexus™ 4x4 uses the DMX data connection for its Master/Slave
mode. See the User Manual to connect and configure for Master/Slave
operation.
Wire (U.S.)
Wire (Europe)
Black
White
Green/Yellow
Green/Yellow
3
Nexus™ 4x4 QRG
Screw Color
Brown
Yellow/Brass
Blue
Green
Silver
Publicité
Table des Matières
