Installation Instructions For Wse Sleeve - Friedrich WallMaster WCT08 Manuel D'installation Et D'utilisation

Installation Instructions for WSE Sleeve

(WSE Sleeve Accessory Sold Separately)
WARNING
Falling Object Hazard
Not following Installation Instructions
for mounting your air conditioner can
result in property damage, injury, or
death.
Mounting Hardware
ITEM DESCRIPTION
NO
1 SCREW, #12A x 2"
Figure 48
24" MINIMUM REQUIRED FROM
TOP OF UNIT TO CEILING
1" MINIMUM SPACING REQUIRED
ON ALL SIDES OF UNIT
/ " MINIMUM BEYOND
7
8
INSIDE WALL
1" MINIMUM
3 / " FOR SUBBASE
1
2
5 / " MAXIMUM FOR SUBBASE
1
2
QTY.
7
INSIDE
WALL
Wall Preparation
STEP 1. The wall opening required for a WSE SLEEVE is 17 ¼" high by
27 ¼" wide.
STEP 2. LINTELS must be used in opening of brick veneer and masonry
walls to support the material above the WSE SLEEVE. The
following considerations should also be given:
A. Masonry walls to support the material above the WSE SLEEVE.
B. Adjustable SUBBASE (SB) or other unit support must be
provided for panel wall type construction and for walls less
than 8" thick.
SIDE VIEW
LINTELS
5" (127 mm)
5" (127 mm)
WALL MOUNT
SCREW LOCATIONS
OUTSIDE WALL
WSE SLEEVE
DRAIN EXTENSION
/ " MINIMUM BEYOND
9
16
OUTSIDE WALL
FRR011
25