Product Certifications; Packaging And Supplied Accessories; Transport And Handling - CHAFFOTEAUX 150 L Notice D'emploi Et D'installation

1.4 Product certifications

The CE marking of the appliances attests its conformity to the following EC Directives, of which it satisfies the
essential requisites:
- 2006/95/EC on electrical safety (EN/IEC 60335-1; EN/IEC 60335-2-21; EN/IEC 60335-2-40);
- 2004/108/EC on electromagnetic compatibility (EN 55014-1; EN 55014-2; EN 61000-3-2; EN 61000-3-3);
- RoHS2 2011/65/EU on restriction of use on certain hazardous substances in electrical and electronic equipment
(EN 50581).
- Commission Regulation (EU) no. 814/2013 on ecodesign (no. 2014/C 207/03 - transitional methods of
measurement and calculation)
Verification of performance is carried out through the following technical regulations:
- EN 16147;
- CAHIER DE CHARGE_103-15/B_2011 Chauffe-eau Thermodynamiques pour la marque NF élettricitè
performance;
- 2014/C 207/03 - transitional methods of measurement and calculation
This product complies with:
- REACH Regulation 1907/2006/EC;
- Commission Delegated Regulation (EU) no. 812/2013 (labelling)

1.5 Packaging and supplied accessories

The device consists of an external unit (heat pump) and an internal one (water heater), this could be anchored to a
wooden pallet (only 300L model), Both units are protected by polystyrene buffers and cardboard on the outside; all the
materials are recyclable and eco-compatible.
The following accessories are included:
- Shielded probe connection cable between units;
- Connection pipe for condensation water of the external unit;
- Drainage pipe for condensation water;
- Wall hole protection;
- Instruction manual and warranty documents;
- One 3/4" dielectric coupling.
- Rubber grommets and cable clips with screws.
- Energy label and product fiche.

1.6 Transport and handling

Upon delivery of the product, check that the latter has not been damaged during transport and that no signs of
damage appear on the packaging. In the event of damages, immediately notify any claims to the forwarder.
WARNING! Absolutely imperative that the external unit is handled and stored in an upright position, with the
aim of ensuring adequate provision of oil inside the cooling system and avoid damage to the compressor.
The indoor unit can be moved both vertically and horizontally.
The packaged unit can be moved by hand or with forklift trucks, taking care to respect the directions above. It is
recommended to keep the product in its original packaging until you install it in the selected area, particularly in the
case of a construction site.
After unpacking, check for accuracy and completeness of the supply. In case of non-compliance, please contact the
seller, taking care to make a communication within the law.
WARNING! Keep the packaging elements out of the reach of children, as they are potentially dangerous.
When transporting or handling the appliance after the initial start-up, observe the aforementioned indication
concerning the allowed tilt angle of the external unit, and ensure that all water has been drained from the tank. If the
original packaging missing, provide an adequate protection for the appliance to prevent any damages, for which the
manufacturer shall not be held liable.
Heat pump water heater – GENERAL INFORMATION
34