Making Connections; Connecting The Surroundbar Speaker To The Dvd Console; Am/Fm Antenna Connections - Polk Audio SurroundBAR 360 Manuel Du Propriétaire

MAKING CONNECTIONS

FIGURE 6
CONNECTING THE SURROUNDBAR SPEAKER
TO THE DVD CONSOLE.
One connection is all that's required to hook up your SurroundBar360°
Speaker System to the DVD Console.
SCART Output for 230 Volt Model (European)
FIGURE 7

AM/FM ANTENNA CONNECTIONS

1
10 Contact Polk Audio Customer Service: 1-800-377-7655 (Worldwide: 1-410-358-3600) Monday-Friday, 9:00 AM-6:00 PM Eastern Time, polkcs@polkaudio.com
Notch on connector
Back of the
SurroundBar360°
DVD Console
2
Important Note: Don't Forget to mute your TV's Speaker before
playing the SurroundBar360° DVD Theater.
Notch on connector
must be on top.
must be on bottom.
AM/FM ANTENNA CONNECTIONS
To set up an AM and/or FM antenna for best reception, follow the directions for each
type of antenna. You may use an outdoor antenna rather than the supplied antennas,
but we recommend working with a qualified installer. Always follow the safety
instructions supplied with any antenna.
FM Antenna:
Attach the FM antenna to the FM connector on the back of the DVD
1
Console. The FM antenna forms the letter "T" when its arms are fully
spread out. Move the antenna around to find the best reception.
AM Antenna:
Attach the AM loop antenna to the AM connector on the back of the
2 DVD Console. The antenna wires are secured in the AM connector by
spring-loaded clips. The AM antenna should be located at least two
feet from the DVD Console. Move the antenna to find the best reception.
Back of the
SurroundBar360°
Speaker