Maintenance And Care; Information On Disposal; Technical Data - AEG LED TAGFAHRLICHT Instructions De Montage

Damages resulting from improper handling, ignoring the instruction manual or intervention by unauthorized
personal are excluded from liability. Do not open the daytime lights. Repairs are to be carried out by qualified
service personnel only.
Installation- and Warning Instructions
• Before assembly check whether the installation depth behind the bumper/cooler grid is sufficient, never
reduce cool air feed for brakes or intercooler, respectively damage hoses, electrical cables or stabilising
struts.
• Daytime lights illuminate automatically as soon as the ignition is switched on and as long as the head lights
(parking, head, fog or full beam lights) are switched off. Rear lights are not allowed to shine in Germany
when daytime lights are switched on.
• Strictly observe the installation dimensions and the legal regulations.
• Please observe the safety instructions and requirements specified by the manufacturer and motor vehicle
trade.
• If you are not familiar with the car electrics, we recommend the installation be carried out by a qualified
garage or a garage authorized by your car manufacturer.
• Always disconnect the minus and plus pole of your car battery when working on the car electrics, because
short circuits could result when installation errors occur.
• If the car has additional batteries, disconnect them also from the car electrics.
• Possible short circuits can damage or destroy components or electronic systems (airbag, engine control
systems etc.).
• After disconnecting the minus pole respectively plus pole from the battery, all volatile electronic memories
such as board computer, time switches and radios lose their stored values. Therefore please note the radio
code before installation.
• Please point out to the customer when handing over the vehicle that he might have to re-program the data
for e.g. the seat position, cruise control, time switch or auxiliary heating.
• The manufacturer checks continuously, if the compliance of the product is kept to the latest requirements.
The manufacturer of this system does not however accept any liability for damages caused by faulty instal-
lation or improper operation.
You will find the installation instructions with diagrams at the end of the instructions

Maintenance and Care

Maintenance for daytime lights is not necessary. To clean the diffusion plate, please use a wet cloth without
aggressive cleaning agents.

Information on disposal

Please dispose of the packaging and electric components environmentally friendly. According to
EU guidelines 2002/96/EC for electrical and electronic waste and transition into national law,
old electronic devices have to be collected separately and recycled environmentally friendly.
Please contact your local authorities about the disposal possibilities of old electronic devices.

Technical Data

Operating voltage:
Capacity:
Type of bulb:
Temperature range:
12/24 V DC
7 W
2 x 18 High Performance LED
- 25 – + 85 °C
GB | 5