Charcoal filter replacement
The charcoal filter, which was enclosed with your
microwave oven, is used for nonvented, recirculated
installation (Room Venting). The filter should be changed
every 6 to 12 months depending on use.
Disconnect power to the microwave oven at the circuit
1.
breaker panel or by unplugging.
Remove the vent grill mounting screws.
2.
Pull the vent grill away from the unit.
3.
Troubleshooting
If you encounter a problem, it often will merely be
something minor. Before you call customer service,
consider the suggestions and instructions below:
Problem
Neither the microwave's display
nor oven operates.
Oven display works, but the
oven will not operate.
Note: If the oven is set to cook for more than 30 minutes at 100% power level, it will automatically adjust itself to a
80% power level after 30 minutes to avoid overcooking.
Suggestion
Properly insert the plug into a grounded power outlet.
▯
Remove the plug from the outlet, wait 10 seconds, then plug the microwave in
▯
again.
Reset the household circuit breaker or replace any blown fuses.
▯
Plug a different appliance into the power outlet. If the other appliance will not
▯
operate, have a qualified electrician repair the outlet.
Plug the microwave into a different power outlet.
▯
Make sure the oven door is closed securely and completely.
▯
Check to see if packing material or other materials are stuck to the door seal.
▯
Check for damage to the oven door.
▯
Press the Clear/Off key twice and attempt to re–enter cooking instructions.
▯
Change the charcoal filter.
4.
Carefully push the vent grill back into place and
5.
replace the screws removed in Step 2.
Note: If no charcoal filter is installed, it is not possible
to bind the odorous substances in the cooking
vapours.
21