On completion of wet vacuum clean-
ing: Clean the flat fold filter using the
dedusting function. Clean the elec-
trodes with a brush. Clean the con-
tainer with a moist cloth and dry it
off.
Clip connection
The suction hose is equipped with a
clip system. All accessory parts with a
nominal width of 35 mm can be con-
nected.
Illustration F
Operation
Switch on the device
1. Switch on the device at the main
switch.
Semi-automatic filter dedusting
Note
Actuating the semi-automatic filter de-
dusting every 5-10 minutes extends
the working time of the flat fold filter.
Note
The semi-automatic filter dedusting
can only be switched on when the de-
vice is switched on.
1. Press the semi-automatic filter de-
dusting button 5x. The flat fold filter
is then cleaned by a blast of air
(pulsing noise).
2. Power dedusting (for particularly se-
vere contamination of the flat fold fil-
ter): Close off the suction pipe or
angle piece with your hand and
press the semi-automatic filter de-
dusting button 5x with the device
switched on.
Cleaning mode
Note
During the basic cleaning of textile
coats, the battery run time is shortened
due to increased cleaning perfor-
mance.
1. Perform cleaning.
Switching off the device
1. Press the semi-automatic filter de-
dusting button 5x.
2. Switch off the device at the main
switch.
Each time after use
1. Empty the container.
2. Vacuum off the inside and outside of
the device and clean with a moist
cloth.
Storing the device
1. Store the suction pipes and suction
hose as shown in the illustration.
Illustration G
2. Store the device in a dry room and
secure it against unauthorised use.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device
during transportation.
1. Remove the suction hose with floor
nozzle from the support. Carry the
device by the carrying handle and
suction pipe.
2. When transporting the device in ve-
hicles, secure it to prevent it from
slipping or overturning in accord-
ance with the respective valid guide-
lines.
English
Transport
9