JCI1: Chassis Intrusion Connector
This connector allows you to connect the chassis intrusion switch cable.
Using chassis intrusion detector
1. Connect the JCI1 connector to the chassis intrusion switch/ sensor on the chassis.
2. Close the chassis cover.
3. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
4. Set Chassis Intrusion to Enabled.
5. Press F10 to save and exit and then press the Enter key to select Yes.
6. Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
1. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
2. Set Chassis Intrusion to Reset.
3. Press F10 to save and exit and then press the Enter key to select Yes.
JTPM1: TPM Module Connector
This connector is for TPM (Trusted Platform Module). Please refer to the TPM security
platform manual for more details and usages.
Normal
(default)
1
1
LPC Clock
3
LPC Reset
5
LPC address & data pin0
7
LPC address & data pin1
9
LPC address & data pin2
11
LPC address & data pin3
13
LPC Frame
Trigger the chassis
intrusion event
2
14
13
2
3V Standby power
4
3.3V Power
6
Serial IRQ
8
10
12
14
Overview of Components
5V Power
No Pin
Ground
Ground
31