Attention For Operation - Gima OXY-200 Mode D'emploi

In trend review mode ,the pink number on the left bottom is current recording time point of the
trend graph,the middle azury font is SpO
the right bottom is PI value.Press "up button" or "down button" to page up or page down;press
"left button" or "right button" to move the recording time which is denoted by pink triangle.
Close the device
a In the main menu interface, move the choice bar to the "Power " item,then press menu button
to close the device.If the record function has been opened,the prompt interface of
"Recording..." will appear when closing the device.It means that the device is in the record
state,can't be closed.
b In the state of boot-strap,long press power button could close the device too.
6.1.4 PC software operation
Please connect the device to the computer by data line, then double click "SpO
to run the PC software.The functions such as uploading real time/memory data and change
device ID could be carried out by the software.Please refer to <SpO
detail.
If the users choose to turn on the display function on computer, it would probably take
several seconds for the data to appear on the computer screen.(If there is no data on the
computer screen ,unplug data line,then repeat step E again .)
6.1.5 Charge
Connect the device to power supply with power line.
When the device is closed and the battery is charging up,short press power button and the
device will display dynamic charge icon ,it means that the device is charging up.When the
battery status is full,the charging has been finished.When the device is open and the battery is
charging up,the battery status icon on the right top will display dynamically.It means that the
device is charging up.When the battery status is full,the charging has been finished.

6.2 Attention for Operation

A lease check the device before use, and confirm that it can work normally.
B The finger should be in a proper position (see the attached illustration of Figure 4 for
reference), or else it may result in inaccurate measure.
C The ray between luminescent tube and photoelectric receiving tube must get across subject's
arteriole.
D The device should not be used at a location or limb tied with arterial canal or blood pressure
cuff or receiving intravenous injection.
E Ensure nothing, such as a plaster, can impede the light passage., or else it may result in
inaccurate measure of SpO
F Excessive ambient light may affect the measure result. It includes fluorescent lamp, dual ruby
light, infrared heater, direct sunlight and etc.
G Exquisite action of the subject or extreme electrosurgical interference may also affect the
accuracy.
value,yellow font is pulse rate value,the green front on
2
,pulse rate and PI.
2
15
Assistant" icon
2
Assistant user manual> for
2