Miele MF03 10 Notice De Montage page 38

Produktgruppe 512
38 von 40
Danger!
Even with the machine switched off, voltage may be applied to some components.
Before starting any service work, the machine must be disconnected from the power supply. Suitable measurements must be made to
ensure that this is the case.
A general visual check and risk evaluation should always be carried out. Incorrect conversion or service work can be dangerous (risk of
fire, electric shock, etc.).
Danger!
Correct grounding function can be deactivated if casing parts are incorrectly assembled.
Correct grounding function must be ensured when reassembling the casing.
Carry out appropriate electrical safety checks.
Danger!
During installation, all accessible conductive parts that are not connected to ground must not have any link to ground (strengthened
double insulation).
To confirm this, insulation resistance and touch current measurements must be carried out.
Note
This installation kit contains:
1 EZL 235 electronic, module 5 (liquid dispensing 7-11 and WRG)
4 spacers (for securing the EZL 235 electronic)
1 coded plug MFM 3-5 (module 3 EZL 235 ST3), pin 3-5
1 coded plug WRG 1 (module 3 EZL 235
1 coded plug MFM 53X (module 3 EZL 235
1 plug N1Q-ST11A (module 3 EZL 235 ST11), pin 1-2
1 wiring harness 20X-41X (module 3 EZL 235
1 wiring harness N1Q_ST112, N1Q_ST11 (module 3 EZL 235
3 black wires, 0.75x90
1 screw terminal 4-pin/ecru
1 screw terminal 4-pin/red
1 screw terminal 6-pin/blue
1 screw terminal 7-pin/green
1 terminal strip 1X3-4 orange
1 terminal strip 2X3-4 gray
1 terminal strip 3X3-4 blue
1 terminal strip 4X3-4 green/yellow
1 liquid dispensing accessory
1 wiring diagram, PW 6107 PW 6207 module 2, mat. no. 09082720
These instructions.
List of illustrations:
Fig. 1, EZL 235 electronic installation
Fig. 2, EZL 235 wiring, module 3, liquid dispensing 7-11 and water recycling (WRG)
Fig. 3, Installing the cable guide on the connection strip
Disconnect the machine from the electrical supply and gas supply (if applicable) and ensure that power cannot be switched on again
in error.
Remove the left and right screws from the machine lid.
Pull the lid slightly forward, push it back and unhook it from the connection strip.
Remove the lid.
Install the EZL 235 electronic with the 4 spacers in the pre-existing holes on the side of the module holder; see Fig. 1, Pos. 1, Pos. 2.
Install the terminal strips in the pre-existing holes on the module holder; see Fig. 1, Pos. 3.
10.02.2012 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
ST6), pin 2-3
ST7), pin 1-2, 3-4
ST10 / module 1 EZL 235
ST111 / module 1 EZL 235
Umbau- und Montageanweisung
M.-Nr. 09087200
ST9), 3-pin, 500 mm
ST112), 4-pin, 350 mm