Options And Accessories - Hatco GLO-RAy GRSS Série Manuel D'installation Et D'utilisation

OPTIONS AND ACCESSORIES

4" Adjustable Legs (GRSS Model)
Use the following procedure to install 4" (102 mm) adjustable
legs in place of the rubber feet on a GRSS unit.
NOTE: 4" (102 mm) legs are included with models greater than
36" (914 mm) in width.
WARNING
ELECTRIC SHOCK HAzARD: Turn power switch OFF, un-
plug power cord, and allow unit to cool before performing
any maintenance or cleaning.
NOTICE
Do not lay unit on the side with the control panel or dam-
age to unit could occur.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Carefully turn the unit upside down and lay the unit on a flat
surface. make sure to cover the surface with something to
prevent scratching the stone surface.
3. at each corner of the base, remove the foot screw and
rubber foot.
Installing the 4" Legs
4. at each corner of the base, screw a 4" leg into the bottom
of the base.
Note: The feet on the 4" legs are adjustable for leveling the
unit. Use a 5/8" (16 mm) open-end wrench to make
leveling adjustments once the unit is placed in its final
position.
4" Leg
Handles (GRSS Models only)
Designer black powdercoated rounded stainless steel handles
are available for GRSS models.
The handles are field retrofittable and are installed onto each
end of the unit using the following procedure.
On each end of the unit:
1. Remove the three nuts located on the underside of the
stone surface support ring.
2. align the three holes on the handle with the three studs on
the support ring, and position the handle on the studs.
3. Replace the three nuts onto the studs, and tighten securely.
Handle
Handle Installation
Recessed Top for GRSSB Models
an optional recessed top is available for GRSSB models. Units
with a recessed top allows the heated surface to sit lower than
countertop surface.
14
English
Support
Ring
Stud
Nut
Form No. GRSSm-0615