Initial Setup; Adjustment Options; Additional Functions; Maintenance And Care - swissflex _75K Mode D'emploi

CAUTION! The _75K and accesso-
ries must be protected from rain
and other moisture to prevent
causing a fire hazard or the risk
of electric shock. When instal-
ling the slat base, ensure that the
head, back and foot sections are
not obstructed by furniture.
Ensure that the mains supply is
disconnected before any assem-
bly or disassembly work is carried
out on the slat base or the bed
frame.
Handle the _75K and accessories
with care; do not disassemble or
modify them, do not allow child-
ren to play with them and prevent
frail individuals from using the
product without supervision.
The product may not be used with
a medical device or be installed in
a medical device.
The product may not be used in an
environment in which flammable
or explosive gases or vapours (e.g.
anaesthetics) are likely to occur.
The product may not be used to
raise and lower loads. Only use
spare parts that have been produ-
ced or a proved by Swissflex. Only
these parts guarantee adequate
safety.
EN

Initial setup

Connect the cable remote control to the motor housing
(7) of the _75K.
Connect the power supply unit with integrated mains
isolation (8) from the _75K motor housing to a power
outlet.

Adjustment options

To preset your sleep position, the head piece can be
manually locked in one of four positions. The setting
of the back section has virtually no impact on the end
position of the head piece.
The remaining comfort zones can be adjusted indivi-
dually via the single function buttons (1 – 4) or jointly
via the combined button (5+6).
Resetting all comfort zones to the horizontal posi-
tion
Press and hold the button (6), until all comfort zones
have reached the horizontal position and the motors
have stopped. In case of a power failure, the basic
position can only be reached through the emergency
set-down function.

Additional functions

Controlling a second slat base
A second slat base can be controlled individually or
jointly through parallel controls. The parallel cont-
rols are available as an optional accessory from your
Swissflex stockist.
Connecting the parallel controls
Connect the cable remote control to the relevant con-
nector at the parallel controls and connect both ends
with the motors (7).

Maintenance and care

Do not store or use the _75K and accessories in extre-
me temperatures in excess of 60°C, as this can lead to
malfunctions and deformation of parts. The _75K has
been designed for use in temperatures between + 5 °C
and 40 °C.
Disconnect the mains cable (8) from the power outlet,
before installing or removing a slat base. Do not feed
cables through the adjustment mechanism to prevent
Operating instructions
11