Adjustment options
The back section can be adjusted with the motor up/
down button (2, 3).
Care and Maintenance
Your _35RF bridge
/ _35RF is a high-quality prod-
®
uct that has been designed to serve you reliably for
many years to come. For occasional cleaning and the
removal of dust from your slat base, we recommend
the use of a dry cloth.
Changing the batteries in the radio remote control
Remove the cover from the battery compartment
(4) on the back of the radio remote control. Place
two AAA batteries into the compartment, paying at-
tention to the +/- markings. Close the compartment
cover again.
Changing the batteries at the switching power
supply of the _35RF bridge
emergency lowering)
Remove the cover of the battery compartment (7) on
the underside of the switching power supply. Care-
fully remove the batteries from the battery clips.
Place two 9V block batteries in the compartment,
paying attention to the +/- markings. The batteries
provide power in the case of a power failure.
What to do in case of malfunction
Loss of power in the sitting position
To readjust your bed to the flat position after a power
outage, you must connect the block batteries and
press the emergency-lowering button on the radio
receiver (9). The batteries of the switching power
supply provide the power required to reset the
motor. Repeated use of the emergency lowering
function puts a significant strain on the batteries, in
which case they must be replaced.
All functions fail
Is mains voltage supplied? Check by switching on
your reading light. If there is no power, check the
fuse.
Motor fails
Check the supply lines and restore if necessary. If
these checks and measures do not resolve the prob-
lem, contact your expert stockist without delay.
EN
/ _35RF (batteries for
®
Technical data
Supply voltage: 230 Volt / 50-60 Hz
Remote control power supply: 2 x AAA-battery
Power rating motor: 60 W
Thrust motor: 4000 N
Power supply for emergency lowering:
2 x 9 V block battery
Total connected load: 60 W
Operating instructions
15