Product Identification; Product Description - CAMPAGNOLA Speedy Manuel D'utilisation Et D'entretien

3.1

Product identification

A CE identification plate / label is applied to each machine / tool (Picture 1).
Model, serial number and year of manufacture are shown on the Manufacturer's CE plate. The CE plate is applied
on the machine / tool and shows the following data and symbols:
1) Compliance marking according to the 2006/42 / CE directive.
2) Company name and full address of the Manufacturer / Constructor.
3) Mandatory prescription for all personnel being responsible for the use and / or maintenance of the machine / tool
as per the corresponding use and maintenance manual.
4) Machine / tool designation.
5) Type of machine / tool - Designation of the type / code of the machine / tool.
6) Serial number.
7) Year of construction, i.e. the year in which the manufacturing process was completed.
8) Information pursuant to the 2012/19 / EU "WEEE" Directive: Electric and electronic waste may contain substances
that are dangerous for environment and human health. Therefore, they must not be disposed of with the household
waste. They must be carried to a waste collection center to be collected separately.
9) Power supply voltage of the tool (only for battery-operated tools).
For a correct and clear identification of the tool, reference must be made to type, serial number and year of con-
struction shown on the identification plate. Mention them to Campagnola Srl for any request for intervention or
assistance.
The CE marking is unique and certifies the compliance of the product with the machinery directive and other
applicable directives according to the conditions prescribed and reported in this manual.
In the case of a "composite" machine / tool, a CE plate / label is attached to the product and a label in sticked on
the tool to identify the type of tool (eg. ATRA.xxxx) constituting the composite machine / tool.
The customer is responsible for verifying the integrity of the CE plate / label.
The user is required to replace the CE plate and / or the warning plates which, due to wear, have become illegible.
It is absolutely forbidden to remove the plates / labels from the machine / tool. Campagnola S.r.l. declines all
responsibility for the safety of the machine / tool if this prohibition is neglected.
DIRECTIVE 2012/19 / EU APPLIES ONLY TO ELECTRICAL AND ELECTRONIC TOOLS AND /
OR EQUIPMENT.
EVEN IF THE CE PLATE / LABEL SHOWS THE SYMBOL OF THE
BARRED WASTE CONTAINER ON WHEELS, THIS DIRECTIVE DOES NOT APPLY TO PNEU-
MATIC PRODUCTS
3.2

Product description

The product has been designed for cutting or pruning branches with a maximum diameter of 25 mm, depending on the
wood type, in orchards, vineyards, etc. It is battery operated and is composed of a blade, an anvil, a lithium battery, a
battery charger, a toolbox and other components.
Simple to use, it is 8/10 times more efficient than manual shears.
The pruning quality is significantly better than that performed manually.
Page 24
Picture 1
Use and maintenance manual – Translation of
original Instruction. : 04 date 16/09/2021