sunjoe 24V-X2-CS16 Manuel D'utilisation page 15

• When the log is supported along its entire length as
illustrated (Fig. 18A), cut from the top (overbuck).
Fig. 18A
1
• When the log is supported on one end (Fig. 18B), cut 1/3
the diameter from the underside (underbuck). Then make
the finishing cut by overbucking to meet the first cut.
Fig. 18B
• When the log is supported on both ends (Fig. 18C), cut
1/3 the diameter from the top (overbuck). Then make the
finishing cut by underbucking the lower 2/3 to meet the
first cut.
Fig. 18C
1
2
• It is easier to saw a log using the spiked bumper
(Fig. 18D).
– Dig the spiked bumper into the log and use it as a
pivot. Cut with an arched motion to make the bar
penetrate the wood.
– Repeat several times if necessary, changing the point
where you plant the spiked bumper.
Fig. 18D
– When bucking on a slope, always stand on the uphill
2
After completing the cut, wait for the saw chain to stop before
you move the chain saw. Always stop the motor before moving
from tree to tree.
Maintenance
Please contact an authorized Snow Joe
or call the Snow Joe
at 1-866-SNOWJOE (1-866-766-9563) for all maintenance
1
operations not foreseen in this manual. Any operation
performed in an unauthorized service center or by unqualified
personnel will completely invalidate the warranty.
m
WARNING!
• Correct maintenance is essential to maintain the original
efficiency and safety of the machine over time.
• Keep all nuts, bolts, and screws tight to be sure the
equipment is in safe working condition.
• Never use the machine with worn or damaged parts.
Damaged parts are to be replaced and never repaired.
• Only use original Snow Joe
parts. Parts that are not of the same quality can seriously
damage the equipment, compromise safety, and invalidate
the warranty.
m
WARNING!
performing any adjustments, maintenance, or repairs to your
cordless chain saw.
• Use protective gloves when handling the bar and chain.
• Keep the bar encased in its sheath, except when working
directly on the bar or the chain.
• Never dispose of oils or other polluting materials in
unauthorized places.
15
Spiked bumper
Spiked bumper
side of the log. When cutting through the log,
maintain control by releasing the cutting pressure
near the end of the cut without relaxing your grip on
the chain saw handles. Do not let the chain contact
the ground.
+ Sun Joe customer service center
® ®
For your safety and that of others:
+ Sun Joe
®
Always remove the batteries before
+ Sun Joe dealer
® ®
replacement
®