Changing The Finderscope Battery; The Hand Control; Powering The Telescope - Celestron LCM Serie Mode D'emploi

CHANGING THE FINDERSCOPE BATTERY

To replace the StarPointer battery, remove the finder from the
scope and turn it over The battery compartment is located
directly under the large lens assembly Using a small screwdriver
or your fingernail, gently lift straight up on the cover to remove it
The battery is held in place by a spring contact Gently lift this
contact and turn the finder on its side The battery should slip
right out Replace the battery with a 3-Volt CR2032 button cell
battery Slide the new battery under the contact, making sure that
the positive terminal of the battery (the side marked with a "+") is
pointing upward, toward the spring contact The battery should
snap in place Replace the cover by lining up the pins on the cover
with the holes in the finderscope and pressing it down Be sure to
dispose of the old battery according to your local laws

THE HAND CONTROL

The LCM hand control has a phone jack type connector at the end
of its cord
To connect to the scope:
1 . Locate the hand control port on the top of the computerized mount
2 . Push the plug at the end of the hand control cord into the port
until it clicks into place
3 . Slide the hand control downward into its holder on the tripod
leg To remove it, lift straight up

POWERING THE TELESCOPE

The LCM can be powered by 8 user supplied AA size alkaline
batteries or an optional 12V AC adapter
To install batteries into the LCM:
1 . Press the tab on the front of the battery compartment and
remove the cover
2 . Gently remove the battery holder from inside the battery
compartment
3 . Place 8-AA batteries (user supplied) inside the battery holder,
taking care to match the battery polarity with the notations on
the battery holder
4 . Return the battery holder back inside the base and replace
the cover
5 . Flip the power switch to the "On" position The light on the
power button and hand control should come on
NOTE: When replacing the batteries, be sure to replace all 8 batteries with
fresh ones at the same time. Never mix old and new batteries.
Hand Control
Port
Battery Compartment
Release Tab
Battery
Compartment
Power Switch
12v Outlet
Battery Compartment
Release Tab
ENGLISH I 11