Adjusting The Temperature - Glacier bay 873-0127H2 Guide D'utilisation Et D'entretien

Installation (continued)
11
Installing the shower head
□
Make sure the washer (C) is inside the shower
arm (B). Hand tighten the bracket (E) onto the
shower arm (B).
□
Place the washer (F) into the hose nuts on each
end of the hose (G). Connect one end of the hose (G)
to the bracket (E) and the other end to the shower
head (D). All connections should be hand tightened only.
□
Attach the shower head (D) to the bracket (E).

Adjusting the temperature

1
Removing the handle,
escutcheon, and inverter
□
Remove the index (L) from the handle (J),
and then unscrew the handle screw (K) and
remove the handle (J) from the valve body (H).
□
Unscrew the escutcheon screws (AA), and
remove the escutcheon (I) from the valve
body (H).
□
Unscrew the sleeve (1) from the valve body (H).
□
Remove the inverter (2) from the valve body (H).
2
Remove the red limit stop ring
□
Remove the red limit stop ring (1) from the
cartridge assembly (2).
C
D
F
J
L K
1
10
B
E
F
G
G
H
I
1 2
AA
2