Dyna-Glo DGH483CRP Mode D'emploi page 9

ASSEMBLY INSTRUCTIONS
5. Attach Upper front door brace (V) to Cart left side
panel assembly (R) and Cart right side panel
assembly (U) with four M6x16 screws (AA).
Pre-assemble two M4x12 Screws (BB) onto the
Cart right side panel assembly (U) and do not
tighten them. Make sure to leave a 5mm gap
between the screw and Cart right side panel
assembly end cap.
Hardware Used
AA
M6x16 Screw
M4x12 Screw
BB
6. Attach Cylinder Exclusion (T) to rear of left and
right cart side panel with two M6x16 screws (AA).
Hardware Used
AA M6x16 Screw
5
x 4
x 2
BB
6
AA
x 2
9
AA
V
U
R
R
T
U