Dyna-Glo DGH483CRP Mode D'emploi page 22

OPERATION INSTRUCTIONS
Lighting The Grill
Before first use:
Remove all hangings or plastic straps, if present. Before you cook on your new gas grill, it is important
to clean your grill with heat. To do this, operate the grill for approximately 15 minutes with the lid closed
and the control knob in the highest position. This will clean the internal parts by burning off any residue
and odor from the manufacturing process.
If the flame extinguishes accidentally during ignition or operation, immediately TURN OFF the
cylinder valve and then TURN OFF the control knob.
Do not lean over grill when lighting. Read instructions before lighting. Do not put pots on the
sear side burner. Using pots on the sear side burner will result in high carbon monoxide levels.
1. Check that the control knobs are in the
2. Open valve at tank fully by turning
3. Open lid during lighting.
4. Depress and turn control knob counterclockwise
to the high position for the main burners and
times to ignite the burner.
If ignition does not occur in 5 seconds, turn the control knobs to
repeat the lighting procedure.
If the burner still does not light, check that there is gas in the cylinder and follow the match lighting
instructions.
CAUTION
WARNING
O
OFF position.
counter-clockwise.
from
for the sear burner. You may need to repeat several
22
O
OFF position, past the
O
OFF position, wait 5 minutes, and
ignite position,