Dyna-Glo DGH485CRP Mode D'emploi page 24

Care and Maintenance
Burner assembly
removing the Burner assembly
1. Make sure all control knobs are in the OFF
position, gas supply valve is closed, and the
gas hose is disconnected from the gas supply.
2. Open lid and remove warming rack, cooking
grates, and heat tents.
Remove hinge pin as shown in Figure 1.
3. Slide main burners and SearPLUS™ burner out
of firebox.
4. Detach ignition wire from electrode in Figure 2.
Figure 1
Figure 2
24
Warming Rack
Cooking
Grates
Smoker Box
Assembly
HeatTents