Setting The Roger Beep On/Off; Setting The Button Sound On/Off; Rm (Room Monitor) - SilverCrest SPMR 8000 B1 Manuel D'utilisation

SilverCrest SPMR 8000 B1

Setting the roger beep on/off

If you release the PTT button [12] after transmitting your message, the unit will send a roger beep to
indicate the end of the transmission. If necessary, you can disable this roger beep.

Setting the button sound on/off

An acoustic signal can normally be heard each time you press a button. This feature does not apply to the
On/Off button [5] or the PTT button [12]. If necessary, you can disable the button sound.

RM (Room Monitor)

You can use this function to monitor a room. While this function is enabled, the handheld transceiver will
transmit as long as voices or other noises are detected and without having to press the PTT button [12].
This lets you hear these voices or noises on the second handheld transceiver.
24 - English
 Press the Menu
and the current status will flash on the display.
 Press the Up  button [10] to enable (ON) or the Down  button [7] to
disable (OF) the roger beep.
 Press the PTT button [12] to confirm the setting and return to idle mode.
 Press the Menu
the current status will flash on the display.
 Press the Up  button [10] to enable (ON) or the Down  button [7] to
disable (OF) the button sound.
 Press the PTT button [12] to confirm the setting and return to idle mode.
 Press the Menu
shown and the current status will flash on the display.
 Press the Up  button [10] to enable the Room Monitor.
 Press the Down  button [7] to disable the function ("RM OF").
 Press the Menu
 To exit the Room Monitor function, press the Menu
and then press the Down  button [7] as many times as necessary until "RM
OF" is shown. Press the Menu
button [6] nine times. The indication "rO" will be shown
button [6] ten times. The indication "tO" will be shown and
button [6] twelve times. The indication "RM OF" will be
button [6] to confirm the setting.
button [6] to confirm.
button [6] eleven times