NETGEAR GS108E Guide D'installation page 3

2. For each device, insert one end of an Ethernet cable into the port in the
device and insert the other end into one of the Ethernet ports on the switch.
ProSafe® Plus Switch
3. Connect the power adapter cord into the back of the switch and then plug the
adapter into a power source (such as a wall socket or power strip).
4. The Power light should light up.
Power
5. Check the LEDs to confirm that all connections are correct.
LED Activity
Power • On: Switch has power.
• Off: No power.
RJ-45 ports • Right LED on: 10 Mbps connection to a powered device.
• Left LED on: 100 Mbps connection to a powered device.
• Both LEDs on: 1000 Mbps connection to a powered
• Blink: Activity on this port.
GS108E
LED
100 Mbps
device.
English
Firewall
Both LEDs light for
1000 Mbps connection
2
Modem
10 Mbps LED
a
Reset