Metal Rack; Signal Tones - CASO DESIGN BMG 20 Mode D'emploi Original

12.1.1

Metal rack


The metal rack can be used for browning of smaller portions and supports even heat
distribution.
 Place the metal rack into the device with the round spacer facing the direction of the
inner rear wall. Check that the metal rack is placed correctly.

12.2 Signal tones

The device transmits the following signal sounds as an acoustic feedback signal:

One signal tone: The device has accepted the entry.

Two signal tones: The device has not accepted the entry. Check the entry and try
again.

Four signal tones: The cooking time has ended.
Attention
► The rubber stoppers may not be removed
from the metal rack.
► Only place the metal rack in the direction
displayed in the diagram.
► Do not place the metal rack on the Ceramic
bottom.
54