POWER SUPPLY FOR THE MINI-BIKE
Please observe the following notes on the power supply and on the power cable in order to avoid
short-circuits and electrical shocks.
- The Mini-Bike is supplied with electrical power via a wall socket. Insert the power plug into a grounded
wall socket. We suggest not connecting additional electrical appliances to this wall socket, e.g. with
assistance of a multiple socket, because otherwise the electronics of the computer and the motor
could be damaged. In this case the guarantee for the Mini-Bike will be expired.
- Before each training make sure that the power plug is completely inserted into the wall socket and
does not wiggle.
- Always pull the power plug, if you do not use the equipment, if you clean it, maintain or build it up to
avoid an electrical shock. Never leave the Mini-Bike unsupervised, as long it is connected to the
electric mains. Always pull at the power plug, never pull at the power cord to disconnect the power
plug from the wall socket.
- Rotate the controller to the OFF position und pull the power plug to turn off the Mini-Bike.
- If you notice damage at the power cord, do not train under any condition with the equipment and
replace absolutely the damaged cord before the next training.
- Pay attention the power cord is not jammed by any objects.
- Do not twist or knot the power cord together.
OPERATION OF THE MINI-BIKE
Important! Place the Mini-Bike on flat and stable surface. We suggest laying a skid-proof pad e.g. a
rubber mat or the like, under the equipment in order to avoid possible damages to the floor.
1
Rotate the controller (2) to turn on the Mini-Bike and to adjust the desired speed.
2
Perhaps it can happen that the pedals lock due to sudden and strong load. In this case demount
briefly the Mini-Bike, turn it off and turn it on again after a short moment.
Note: after 15 minutes the Mini-Bike turns off automatically. You can continue the training
immediately, if you briefly turn the Mini-Bike off and turn it on again afterwards.
29