PowerPeak FSB8261P Mode D'emploi page 28

COMPUTER COMMANDS
1. Turn on the computer by pressing the MODE button or operate the pedals. The computer turns
off automatically, if for 4 minutes neither the MODE button is pressed nor the pedals are
operated.
2. Indication of the computer:
- Scan (S): all values are displayed alternating in intervals of 5 seconds.
- Calories (CAL): displays the so far consumed calories.
- Timer (TMR): displays the actual training time.
- Distance (KM): displays the actually traveled training distance.
- Cycling Times (REPS): displays the number of actually traveled steps.
- Total Cycling Times (T-REPS): displays the number of total traveled steps.
Please note that the values displayed by the computer can only be used as information and are not
allowed to be used for medical purposes.
3. By the pressing the MODE button the following values are displayed successively:
CAL (Calories)
SCAN (automatic alternating display in intervals of 5 seconds)
TMR (actual training time)
KM (actual training distance)
REPS (number of actually traveled steps)
T-REPS (number of total traveled steps)
CAL (number of the actually consumed calories)
4. Set the values to ZERO (RESET): Hold and press the MODE button for four seconds to reset all
values to ZERO. Except the value of total traveled steps (T-REPS) all values will be reset to ZERO.
You can also reset the value for T-REPS to ZERO by moving with the MODE button to this value
on the display and subsequently hold the MODE button 4 seconds pressed.
Power supply of the computer:
The battery compartment is on the rear of the computer. Open the cover and insert 1 (or 2) button
cell(s) (LR44). Observe the correct polarity and sufficient contact with the battery springs. If the
indication is illegible or individual segments of the digits are missing, please remove the batter(ies)y
for about 15 sec. and insert it again.
28