Instructions For Use; Filling The Jacket; Switch On, Start Of Cooking And Switch Off; Cleaning And Care Of The Appliance - Tecnoinox P70DG7 Instructions D'installation

Before cooking with the appliance for the first time wash the interior of the cooking vat thoroughly.
Warning! : Fill the cooking vat up to a maximum of 40 mm under the overflow border, according
to the maximum level mark, including the food to be cooked.
Warning! : The water level in the jacket must be checked each time before lighting.
Warning! : It is advisable to use softened water to fill the jacket!
Open the level tap on the front of the appliance.
Unscrew the filling cap on the safety valve unit. The latter is on the right of the appliance surface (see
figure "Size of appliance and position of connections ").
Fill with softened water (the capacity of the jacket is stated in the paragraph "Technical data").
When water flows out of the level tap, close it and screw back on the safety unit cap.

3.2.2. SWITCH ON, START OF COOKING AND SWITCH OFF

The appliance is equipped with a selector to start all cooking operations (see figure "Cotrols").
Here is a list of the procedures for a safe and correct use of the appliance.
Lighting the pilot burner:
Open the gas cock before the appliance.
Turn the knob from position "" leftwards to the position "", press the knob and together press the
piezoelectric ignition button repeatedly..
Once the pilot flame is on, keep the knob pressed for a few seconds until the thermocouple heats up.
Starting cooking – igniting main burner:
Turn the knob leftwards to the position "
Generally cooking is started by setting the knob on the maximum heating position and once the vat has
reached cooking temperature, the knob is turned to the minimum position to maintain the cooking temperature.
End of cooking – turning off main burner and pilot burner:
Turn the knob rightwards until position "" to turn off the main burner; only the pilot flame will be lighted.
Turn the knob again until position "" to turn off the pilot burner. (See also figure "Controls").
Do not use aggressive substances or abrasive detergents when cleaning the stainless steel components.
Avoid using metal pads of the steel parts as they may cause rust. For the same reason avoid contact with
materials containing iron.
Do not use sandpaper or abrasive paper for cleaning; in special cases use a powder pumice stone.
In case of particularly resistant dirt, it is advisable to use abrasive sponges (e.g. Scotch-Brite).
It is advisable to clean the appliance only once it has cooled down.
Manuale d'istruzione per l'installazione, la manutenzione e l'uso
Pentole a gas P70.G7 / P8.G7

3.2. INSTRUCTIONS FOR USE

3.2.1. FILLING THE JACKET

"or until minimum position " " to light the burner.

3.3. CLEANING AND CARE OF THE APPLIANCE

05.11.01 - IT pagina 39