Wiring Diagrams; Maintenance And Cleaning - Vortice PUNTO EVO Livret D'instructions

ENGLISH
and the motor runs at the speed set with the jumper. In the remaining 60 seconds the motor will only start after
a signal from the PIR module, at the speed set with the jumper; when there is no signal from the PIR module,
the motor will stop immediately (time lag for switching off = 0). At the end of the "Test Mode" phase, the appliance
will go into normal operation.
Table B
Speed Jumper
Position A Position B
V1 MIN speed MAX speed

Wiring diagrams

Fig. 21 ÷ 25

Maintenance and cleaning

Fig. 26 ÷ 28
57