Before Using For The First Time - TEFAL KI820D10 Mode D'emploi

BEFORE USING FOR THE FIRST TIME

1. Remove all of the various packaging, stickers or accessories from both the inside and outside of
the kettle.
2. Adjust the length of the cord by winding it under the base. Wedge the cord into the notch.
Throw away the water from the first two/three uses as it may contain dust. Rinse the kettle.
USE
1. TO OPEN THE LID, ACCORDING TO THE MODEL
– Press on the locking system and the lid lifts automatically.
To close, press down firmly on the lid.
2. PLACE THE BASE ON A FLAT, STABLE, HEAT-RESISTANT SURFACE AWAY FROM WATER
SPLASHES AND ANY SOURCES OF HEAT.
• Kettle is only to be used with the base provided.
3. FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER.
• You can fill it through the spout.
• Never fill the kettle when it is on its base.
• Do not fill it above the maximum level, or below the minimum level. If the kettle is too full,
boiling water may spill out.
• Do not use without water.
• Check that the lid is closed properly before use.
4. POSITION THE KETTLE ON ITS BASE. PLUG IT INTO THE MAINS SOCKET.
5. TO START THE KETTLE
When the kettle is placed on the base, all the lights illuminate. The water temperature in the kettle
is displayed on-screen.
TO HEAT WATER:
2 options:
– If you wish to start a boil cycle, press the
– If you wish to choose your temperature (8 possible choices: 100° - 95° - 90° - 85° - 80° - 70° - 60°
- 40°), press the button until you obtain the desired temperature.
Once the temperature has been selected (either via
automatically after 2 seconds, then the kettle produces a sound once the selected temperature
has been reached (accuracy +/- 3°C).
To stop the current cycle, press any button.
PLEASE NOTE
For the 40°C temperature setting, we recommend putting water to the minimum indicated in the
kettle to improve the sensor's accuracy.
However, water temperature may vary depending on external conditions.
It is critical to always check water temperature before drinking your preparation.
KEEP WARM FUNCTION
Your kettle has a keep warm
will be heated to this temperature, then kept warm for 1 hour after a long press of 2 seconds on
the or button. The
done, the kettle produces a sound.
The maximum temperature for the keep warm function is 95°C.
The keep warm function may be stopped by a short press on the
NOTE
The screen and buttons automatically shut off after 30 seconds have elapsed (except when
button
function. If the user has pre-selected a temperature, the water
indicator will light up for 1 hour. Once the keep warm mode is
13
(fig 2)
(fig 3)
or via ), the heating cycle starts
or button.
EN
(fig 1)