ASBER EASY-H500 Manuel D'instructions page 53

asberprofessional.com
Machine stops during op‐
eration.
Machine stops and fills with
water when it is washing.
The machine does not start
with the wash cycle.
n
52
asberprofessional.com
Electrical installation
overloaded.
Machine
has tripped.
Pressure switch pipe
blocked.
Pressure switch faulty. Call the technical service to replace it.
Overflow incorrectly
mounted.
Hood is not closed
properly.
Hood micro switch
faulty.
NOTE: If a fault occurs and is not listed in the above table, please call
the technical service. The manufacturer reserves the right to modify
the technical characteristics with prior warning.
Call technical service to modify electrical installa‐
tion.
protection Reset safety device and if it trips again, call techni‐
cal service.
Empty the tub and clean thoroughly.
Mount overflow correctly.
Close the hood correctly and if it is seen to re‐open
alone, call the technical services to adjust the spring
hinges.
Call the technical service to replace it.
ENGLISH