Pratissoli LK Serie Manuel De Réparation page 47

Remove the tool for blocking the con-rods code 27566200
(pos. , Fig. 40) and roll back the connecting rods until they
touch the bend shaft.
Insert the pre-assembled PTO shaft into the casing (pos. ,
Fig. 55). Insert it from the other side to the side where the
external bearing ring and the bearing lubrication bush were
inserted.
The PTO shaft must be inserted into the casing so
that the teeth are oriented as shown in Fig. 55.
It is easier to insert the PTO shaft completely inside the
bearing by applying an M16 screw to the end of the shaft
being inserted, to keep the shaft lifted up (pos. , Fig. 56).
From the side of the casing where the PTO shaft was inserted,
proceed to insert the bearing lubrication bush (pos. , Fig. 57)
and an external bearing ring (pos. , Fig. 58) using a buffer
and an extractor hammer.
Fig. 54
At both sides, insert the internal bearing spacers (pos. ,
Fig. 59) and the external bearing spacers (pos. , Fig. 60).
Fig. 55
Fig. 56
47
Fig. 57
Fig. 58
Fig. 59