Model And Serial Number Location - Electrolux E30IC75FSS5 Manuel D'instructions

INDUCTION COOKTOP INSTALLATION INSTRUCTIONS
DO NOT ground to a gas supply pipe.
DO NOT connect to electrical power supply until
appliance is permanently grounded. Connect the
ground wire before turning on the power.
Where local codes permit connecting the
appliance-grounding conductor to the neutral
(white) wire (see figure 3):
1. Disconnect the power supply.
2. In the circuit breaker, fuse box or junction box,
connect appliance and power supply cable wires as
shown in figure 3.
Cable from Power Supply
White Wire
(Neutral)
Red
Wires
Green Wire (Ground)
Cable from
appliance
Figure 3 - 3-WIRE GROUNDED JUNCTION BOX
You may not ground the cooktop
through the neutral (white) wire if cooktop is used
in a new branch circuit installation (1996 NEC),
mobile home, recreational vehicle, or where local
codes do not permit grounding to the neutral
(white) wire. When grounding to the neutral
(white) wire is prohibited, you must use a 4-wire
power supply cable. See Figure 4. Failure to heed
this warning may result in electrocution or other
serious personal injury.
If cooktop is used in a new branch circuit installation
(1996 NEC), mobile home, recreational vehicle, or
where local codes DO NOT permit grounding to the
neutral (white) wire (see figure 4):
1. Disconnect the power supply.
2. In the circuit breaker, fuse box or junction box,
Black
Wires
Junction Box
U.L.-Listed Conduit
Connector
supply cable electrical system, the appliance frame
connected ground wire MUST NOT be connected to
the neutral wire of the 4-wire electrical system.
NOTE TO ELECTRICIAN: The armored cable leads
supplied with the appliance are UL-listed for connection
to larger gauge household wiring. The insulation of the
leads is rated at temperatures much higher than
temperature rating of household wiring. The current
carrying capacity of the conductor wire is governed by
the temperature rating of the insulation around the
wire, rather than the wire gauge alone.

Model and Serial Number Location

The serial plate is located under the cooktop.
When ordering parts for or making inquires about your
cooktop, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your cooktop.
4
connect appliance and power supply cable wires as
shown in figure 4.
Cable from Power Supply
Ground Wire
Red
Wires
Green Wire (Ground)
Cable from appliance
Figure 4 - 4-WIRE GROUNDED JUNCTION BOX
If connecting to a 4-wire power
Serial plate is located under
the burner box of cooktop.
White Wire
Black
Wires
Junction Box
U.L.-Listed Conduit
Connector