Assembly - Southland SCS2052.1 Manuel D'utilisation

Assembly

• Save these instructions
A
Chute Deflector (Fig. 2)
WARNING
installed and secured with wing knobs.
1. Align hole in discharge chute (12) with holes on chute deflector (10).
13
14
12
2. Slide bolt (13) with washer (14) through sleeve (41), chute deflector (10), discharge
chute (12) and second sleeve (41). Secure with other washer (14) and nut (15).
Tighten using a 10 mm open end wrench or socket. Ensure deflector pivots freely
with no resistance.
3. Close the chute deflector (10). Ensure the discharge chute hooks onto post (16).
Secure chute deflector with wing knobs (9).
B
Debris Bag (Fig. 3)
1. Place the opening of the bag (11) completely over the chute deflector (10).
2. Ensure wing knobs (9) and side tabs (40) are completely covered by the bag and
drawstring.
3. Depress the cord lock (17) and slide it down the drawstring until the bag is secured
in place around the chute deflector. Release cord lock to lock drawstring in place.
Questions? Call Toll Free at 1-800-737-2112
DO NOT operate chipper shredder unless the chute deflector is
10
41
Figure 2A
40
9
14 15
16
9
Figure 2B
10
ENG - 14
If you need assistance or find any parts
missing, CALL TOLL FREE: 1-800–737-2112
17
Figure 3
Copyright © 2015 MAT Engine Technologies, LLC
Figure 2C
11