Atlantic FF4216T Manuel Du Produit page 3

From the inside of the flexible basin, insert the
threaded end of the bulkhead into the
pre-punched hole in the flexible basin. This will
sandwich the rubber gasket between the flange
of the bulkhead and the inside wall of the
flexible basin (Figure 2). Slip the 10" round
backing plate over the threaded end of the
bulkhead on the outside of the flexible basin,
followed by the friction washer and the
retaining nut. Tighten the retaining nut by
hand and then finish offwith a half turn from a
wrench. Note that the retaining nut has reverse
threads. Turn counterclockwise to tighten.
Installing the Flexible Basin
Place the flexible basin within the stone
surround, being careful not to disturb the level
base at the bottom. Starting at the center, use
your hands to smooth out the basin, working
any excess slack towards the outside edges.
Ensure that the basin is tucked tightly into all
corners, and place some stones around the top
edges of the basin to temporarily hold the
basin in place (Figure 3). Begin filling the
basin with water.
Figure 3
Figure 2
Friction
Washer
Retaining
Nut
Backing
Plate
Rubber
Gasket
Bulkhead
Flexible
Basin
3