INSTRUCTION MANUAL (Translation from the original Spanish)
Damage prevention and safety instructions
A Warning! Observe limitations of use.
B The name plate voltage must be the same as the
mains voltage.
C Connect the pump to the mains via an omnipolar
switch with at least a 3 mm opening between
contacts.
D Install a high-sensitivity differential switch (0.03A)
as extra protection against lethal electric shocks.
E Connect the pump to the ground.
F Use
pump
only
indicated on the name plate.
G
Remember to prime pump.
H
Check for motor self-ventilation.
Contents
Safety precautions .................................................... 8
1.
General information ........................................... 8
2.
Handling ............................................................ 8
3.
Installation ........................................................ 8
3.1. Fixing .......................................................... 9
4.
Starting .............................................................. 9
5.
Maintenance ...................................................... 9
6.
Nameplate ....................................................... 10
7.
8.
9.
List of main components ................................. 33
10. Wiring diagrams .............................................. 34
11. Illustrations ...................................................... 35
Safety precautions
This symbol
following words "Danger" or "Warning" indicates the
risk level deriving from failure to observe the
prescribed safety precautions:
DANGER
Warns that failure to observe
the pre cautions involves a
risk of
risk of electric shock.
electric
shock
DANGER
Warns that failure to observe
the pre cautions involves a
risk of damage to persons
and/or things.
WARNING
Warns that failure to observe
the pre cautions involves the
risk of damaging the pump
and/or the facility
within
performance
limits
together with one of the
(See figure 5)
I
This apparatus may be used by children 8 years
or older and persons with reduced physical,
sensory
or
mental
experience
and
supervised or receive adequate training on the
safe use of the apparatus and understand the
dangers.
Children should not be allowed to play with the
apparatus.
Children
should
not
cleaning
and
maintenance
supervision.
J Be
careful
with
environments.
K
Caution! Look out for accidental leaks.
Do not expose pump to bad weather.
L
Caution! Avoid icing.
Cut out power supply before servicing pump.
1. GENERAL INFORMATION
Please observe the following instructions to achieve
the best pump performance possible and a trouble
free installation.
Read these instructions before installing the
pump.
Save them for future reference.
These are single cell centrifugal pumps with built-in
filter elements, especially designed for prefiltering
and recirculation of water in swimming pools.
These pumps are designed to operate with clean
water, free from particles in suspension and with a
maximum temperature of 35 ºC.
Correct pump operation is assured providing
the instructions on electrical connection,
installation and use are strictly adhered to.
Failure to adhere to the instructions can
result in premature failure of the pump and
voiding of the warranty.
2. HANDLING
The pumps are supplied suitably packaged to pre-
vent damage in transit. Before unpacking, check
that the packaging has not been damaged or de-
formed,
Lift and handle the product with care and with
the right tools.
3. INSTALLATION
The installation of these electric pumps is only
permitted in swimming pools or ponds that comply
with standards IEC 60364-7-702 and/or the national
regulations of the country in which the product is to
be installed.
8
capacities,
or
lacking
knowledge,
if
they
perform
the
ordinary
tasks
without
hazardous
liquids
EN
are
and