Sirius SLT950 EM Instructions D'utilisation page 14

Standard configuration
If two cookerhoods-radiocontrol system are
installed in the same room or in the immediate
vicinity, each system may affect the operation
of the other, due to the fact that they have the
same code. Therefore it will be necessary to
change the code of one of the radio controls.
Warning:
The battery should be replaced eve-
ry yearto guarantee the optimal range of
the transmitter. To replace the exhausted
battery, take the plastic lid off, remove the
battery and replace it with a new one, ob-
serving the correct battery polarities. Used
batteries should be discarded in special
collection bins.
Generating a new transmission code
The radiocontrol is supplied by the manufac-
turer with default codes stored. If you want to
create a new set of codes, proceed as follows:
press and hold the UP, STOP and DOWN but-
tons simultaneously for 2 seconds. Afterthe
LEDS light up, press the UP and DOWN button
swithin 5 seconds. The LEDS will flash 3 times
to indicate that the process is completed.
WARNING: This procedure deletes all pre-
viously stored codes.
Learning the new transmission code
After changing the transmission code on the
radio control, the cooker hood electronic con-
trol unit must be made to set the new code
as follows: press the main Power Off button
on the cookerhood and then restore power
to the electronic control unit. Within the next
15 seconds, press the Light button. This will
ensure the control unit is synchronized with
the new code.
MAINTENANCE
An accurate maintenance guarantees good
functioning and long-lasting performance.
A special care must be paid with grease fil-
ters: please follow the following steps to
remove the grease filter, accordingly to the
cooker hood model:
SLT950 SLT951: Open the stainless steel pa-
nel by slightly pulling it downwards, as shown
in fig. 3.
SLT952 SLT952EM: Open the panels by sli-
ghtly pressing them , as shown in fig. 11,
holding them during opening.
After opening the panel completely, remove
the grease filter by pulling the handle.
To reinsert the grease filter after the cleaning,
just perform the opposite operation.
To clean the appliance itself tepid water
and neutral detergent are recommended,
while abrasive products must be avoided. For
steel appliances specialized detergents are
recommended (please follow the instructions
indicated on the product itself to obtain the
desired results).
Attention: after refastening the stainless steel
panel make sure that it is properly fixed.
To replace the dichroic lamp, (SLT950 -
SLT951) remove the lamp (Fig. 9) and replace
it with a lamp of the same kind 1.
It is necessary to disconnect the appliance
from the electrical network to replace the
fluorescent lamps (SLT952 and SLT952EM):
open the panel by slightly pressing it as
shown in fig. 11, and holding it during ope-
ning. Remove the screws shown in fig. 14;
pull out the fluorescent lamps support (fig.
15), and replace the old lamp with a new one
with same characteristics.
Refit the panel and the screws previously re-
moved.
Follow the steps described above to replace
the fluorescent lamps ballast.
14