Specified Conditions Of Use; User Groups - Weller Zero Smog 4V Traduction De La Notice Originale

Specified Conditions Of Use

Applied directives
The Weller Zero Smog volume
fume extraction system
extraction unit corresponds to
the EC Declaration of
Conformity in accordance with
the basic safety requirements
of Directives 2004/108/EC,
2006/95/EC and 2011/65/EU
(RoHS).
The manufacturer will not be
liable for unauthorised modifica-
tions to the device.
Efficiency test
In accordance with the general guidelines of the trade association, fume extractor systems must be
checked regularly, at a minimum annually, in order to ensure that they are fully functional (TRGS 528
BGETF). The efficiency test also serves to check for proper functioning of the WFE 2S / WFE 4S and
Zero Smog 4V / Zero Smog 6V / Zero Smog 20T solder fume extractor systems. Use the supplied soft-
ware CD.

User groups

Due to differing degrees of risk and potential hazards, several work steps may only be performed by trained
experts.
Work step
Installation of complex pipe systems with multiple
extractor arms connected
Replacing electrical replacement parts
Specification of maintenance intervals
Operation
Filter change
Installation of complex pipe systems with multiple
extractor arms connected
Replacing electrical replacement parts
20
This filtration system is suitable for the extraction and filtration of partic-
les and gases, depending on the filter medium used.
Warning! Danger of asphyxiation, Danger of poiso-
ning
Improper use may result in respiratory problems, asphy-
xiation, poisoning or cancer
Particles and gases which are unsuitable for the filter
„
medium in use may not be extracted.
Liquids and flammable gases may not be extracted
„
Never use the device without a filter or with a full filter.
„
Never use the device without the fan cover
„
This device may only be used at room temperature and indoors.
Zero Smog 4V, Zero Smog 6V: The unit is designed for use as a
surface extraction unit and is not suitable for extracting fumes direct-
ly from the soldering gun.
Zero Smog 20T: The unit is designed for extracting fumes directly
from the soldering gun and is not suitable for use as a surface
extraction unit.
Intended use of the soldering station/ desoldering station also inclu-
des the requirement that you
adhere to these instructions,
„
observe all other accompanying documents,
„
comply with national accident prevention guidelines applicable at the
„
place of use.
User groups
Specialist personnel with technical training
Electricians
Safety expert
Non-specialists
Technical trainees under the guidance and supervision
of a trained expert