Baking Sheet; Electrical Connection - CASO DESIGN IMCG25 Mode D'emploi Original

Afterwards push the metal rack down, as shown on photo C.
 Check that the metal rack is placed correctly.
Attention
► The rubber stoppers may not be removed from the metal rack.
► Place the metal rack only in the direction shown on the photo.
► Do not place the metal rack on the ceramic bottom.
12.6.2

Baking Sheet

Use the baking sheet as follows:
Place the baking sheet on the base plate or the metal rack.

12.7 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
 The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under the
oven or over hot or sharp surfaces.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician. The manufacturer cannot be made responsible
for damages that are caused by a missing or damaged protective conductor.
59