Making Coffee - TEFAL CM461811 Mode D'emploi

• Use your filter coffee maker without
coffee the first time using the
equivalent of a jug of water to rinse
the circuits.

Making coffee

(Follow figures 1 to 8)
• Use only cold water and a n°4 paper
filter.
• Do not exceed the maximum water
level indicated on the tank.
• This coffee maker is equipped with a
drip stop so that you can serve coffee
before the cycle ends. Replace the
jug immediately in order to avoid
overflowing.
• Wait a few minutes before you make
coffee a second time.
Programming
Setting the time
• Plug in the coffee maker. The LCD
screen (d) will display 12.00 and
flashes for a few seconds.
• Press the hour Button in order to set
the hour. You may do this repeatedly,
or continually for faster hour
progression.
• AM indicates morning hours and PM,
afternoon and evening hours.
• Once you have set the hour, press the
MINI button for minutes and follow
the same procedure.
• Once the minutes are set, wait for the
flashing to stop and the set time will
be validated. Otherwise, press the
(i) button once.
• The programming will have to be
repeated in case of a blackout or if
the coffee maker is unplugged.
• PLEASE NOTE :You can set or adjust
the time at any moment. Hold the
10
button down for a minimum of 3
seconds . Once the time flashes on
the screen, you may adjust the time
using the hour and Min buttons.
Program mode
• In order to program your coffee
maker, press the PROG button once.
• Set the hour and minutes according
to the time you wish your coffee
maker to start (please refer to
"Programming", above).
• Validate the set time by pressing the
PROG button once more.
• The screen will display the set time
and the green light signal (k) will turn
on.
• In order to display the current time
again, briefly press the
• At the set time, the red light signal
will turn on and the coffee maker will
start.
WARNING: The set program is
automatically deactivated at the
end of the coffee cycle; however,
the set time is saved. Reactivate the
set program every day by pressing
on the PROG button. In order to
set a different time, please refer to
paragraph "Using the appliance in
the Program Mode".
It is possible at all times:
• Turn your coffee maker ON or OFF by
pressing the button.
• Cancel the programming by pressing
the PROG button for 3 seconds. When
you do so, the green light signal (k)
will turn off.
• In order to reactivate the program on
your coffee maker, press the PROG
functioning
button.