Erecting The Awning - Trigano Lima 300 Notice De Montage

ENGLISH

ERECTING THE AWNING

1 - Once your caravan is correctly positioned,
carefully clean the ground whilst erecting the
awning in order to avoid any risk of damage.
The doors and windows of the caravan must
be closed.
2 - Place the awning beading on the awning close
to the caravan channel. Insert it in the channel
and slide it until the awning is in the correct
position (A).
3 - Take the pump and connect it to the inflation
valves.
4 - Begin inflation following the instructions given
in the section PUMP and INFLATION of this
booklet.
Begin by inflating the pole located closest to the
front of the caravan and then inflate the other
poles one after another.
:
ATTENTION
During the inflation process the pole
will need to be manually held to ensure it takes its
rounded form.
To do this, pull the guy ropes located in the roun-
ded section of the pole towards you (B).
Do not continue inflating if the pole does not take
its rounded form.
:
ATTENTION INFLATE EACH POLE TO: 0.344
BARS / 5 PSI. DO NOT INFLATE ABOVE THESE
VALUES AS THIS MAY RESULT IN THE POLES
BURSTING.
Notice LIMA 300 ET 410.indd 16
A
B
4 extra tubes
for model Lima 300
6 extra tubes for model
Lima 410
- 16 -
12/11/2018 17:52