Recommendations; Before Assembly; About The Inflatable Frame - Trigano Lima 300 Notice De Montage

RECOMMENDATIONS

• Assemble the awning at home before setting off on your trip in order to familiarise yourself
with its assembly and ensure you have not forgotten anything.
• Choose preferably a smooth, level plot and remove all stones, twigs, etc...
• Avoid placing the entrance towards the wind.
• Close all zippers before assembly.
• Open all zippers before packing up your awning.
• Condensation (natural phenomenon) is caused by the humidity given off by the occupants,
the air and ground. Droplets therefore form on the inside surface of the awning and may give
the impression that the awning is leaking, but this is not the case!
• In order to limit this condensation, simply air the awning as much as possible using the double
doors with mosquito netting.

BEFORE ASSEMBLY

• Remove all items from the bag and place them on the ground.

ABOUT THE INFLATABLE FRAME

• The frame of the Lima 300 awning is composed of
4 inflatable poles, whereas the Lima 410 awning has 6.
• These inflatable poles are placed in the zipped covers.
They are therefore easy to replace.
• The poles are made of polyurethane (TPU), a material
which resists wear and its porosity to air is almost zero.
• To provide efficient protection against bursting, each TPU
pole is covered with a high-resistance protection made of
polyethylene-lined OXFORD polyester. This cover is closed
with a zipper.
ATTENTION
THE 2 PULLS OF THE ZIPPER ARE AT-
TACHED TOGETHER WITH A PADLOCK.
THIS PADLOCK MUST NEVER BE REMO-
VED AS THIS WILL RESULT IN THE TUBE
BURSTING DURING INFLATION. CUR-
SORS OF EXTRA TUBES ARE ATTACHED
TOGETHER WITH A BENDING . DO NOT
REMOVE THIS BENDING AS WELL.
Notice LIMA 300 ET 410.indd 13
sleeve
cover
- 13 -
ENGLISH
Zipper
12/11/2018 17:52