Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. Using diagonal wire cutting pliers, gently snip out the
rectangular damper vent covers at the perforations.
A
A. Diagonal wire cutting pliers
B. Damper vent covers
7. Reattach blower motor to back of microwave oven
with 2 screws removed in Step 3.
8. Reattach damper plate. Make sure damper plate tabs are
inserted into the slots in the top of the microwave oven.
A
D
A. Damper plate
B. Screws
C. Damper plate tabs
D. Slots
9. Secure damper plate with 2 screws removed in Step 1.
B
B
C
Roof Venting Installation Only
1. Repeat steps 1 to 4 from "Wall Venting Installation Only."
2. Rotate blower motor so that exhaust ports face the top
of microwave oven and flat sides of blower motor face
back of microwave oven. Lower blower motor back into
microwave oven.
A. Exhaust port
IMPORTANT: If blower motor is not positioned with flat sides
facing the back of the microwave oven (as shown), performance
will be poor.
3. Reattach blower motor to back of microwave oven with
2 screws removed in Step 3 of "Wall Venting Installation
Only." Securely tighten screws.
NOTE: If blower motor is not correctly oriented, the 2 screws
removed in Step 3 cannot be reattached to the microwave oven.
4. Using diagonal wire cutting pliers, gently snip out the
rectangular vent covers on the damper plate removed
in Step 1 at the perforations.
A
A. Diagonal wire cutting pliers
B. Rectangular vent covers
5. Reattach damper plate. Make sure damper plate tabs are
inserted into the slots in the top of the microwave oven.
A
D
A. Damper plate
B. Screws
C. Damper plate tabs
D. Slots
6. Secure damper plate with 2 screws removed in Step 1
of "Wall Venting Installation Only."
A
B
B
C
5
Publicité
Table des Matières
