essentiel b ERA 553 Notice D'utilisation page 32

use
Switchingontheunit
Place the unit on a flat, stable surface in an upright position.
1.
Plug the unit into a wall socket. The unit will beep and go into standby mode.
2.
Press the on/off button
3.
indicator lamp will light up and the unit will start, by default, in normal mode
speed .
To turn off the unit, press the
4.
IMPORTANT:
If you need to move the unit when the tank is full, unplug it and
carefully roll it while holding it by the carrying handle to prevent
it from tipping over.
Selectingthespeed
Repeatedly press the
speed:
: low speed
•
: medium speed
•
: high speed
•
The indicator lamp for the selected speed will light up.
Selectingthe
Press the
The indicator lamp for the selected mode will light up:
Normal mode
•
Natural mode
•
Depending on the speed selected in the previous section, the fan cycle differs.
Sleep mode
•
to speed 1 after 40 minutes, and then continues to operate at this speed continuously.
32
V.4.0
use
on the control panel or remote control. The corresponding
button again. The control panel will switch off.
button on the control panel or remote control to select the fan
mode
button on the control panel or remote control to select the operating mode.
: the fan speed remains constant.
: the fan speed randomly changes to reproduce the effect of a breeze.
: when the selected fan is in speed 3, it switches to speed 2 after 30 minutes,
at low