Safety Instructions/Warnings - Fellowes Corsivo Manuel D'utilisation

SAFETY INSTRUCTIONS/WARNINGS

Read and follow all instructions and warnings before use.
• WARNING: PINCH POINT! KEEP HANDS CLEAR OF SUPPORT BARS DURING
OPERATION. SERIOUS INJURY MAY OCCUR.
• DO NOT EXCEED MAXIMUM STATED WEIGHT CAPACITY. SERIOUS INJURY OR
PROPERTY DAMAGE MAY OCCUR.
• Keep cables clear of support bars during operation, follow the cable routing
instruction in this manual. Failure to follow these instructions may result in
equipment damage or personal injury.
• DO NOT lean on the keyboard platform.
• Always use both hands when operating the workstation.
• Make sure the desk or mounting surface is level and can support the combined
weight of the workstation and accessories.
• Remove all equipment and accessories from the workstation before moving.
• Only compatible with Fellowes Monitor Arm Kit for Lotus.
• Manufacturer certifies that product meets or exceeds applicable
ANSI/BIFMA standards.
CONTENTS
Included
A Workstation
B Keyboard Platform
C Threaded Insert/M5x10mm
Pan Head Phillips Screw
A (x1)
D Adhesive Cable Clips
E Foam Pads
F Rubber Feet
Other Tools Required
Phillips Screwdriver
C1/C2 (x4)
2
Corsivo_411433_RevC_10L_111419.indd 2-3
ENGLISH
Corsivo™ Sit-Stand Workstation
≤ 15 Kg
≤ 33 lbs
≤ 2 Kg
≤ 4.4 lbs
B (x1)
D (x4) E (x2) F (x4)
SET UP
STEP 1
Remove four M5x10mm pan head Phillips screws (C2) from threaded inserts (C1) using a Phillips screwdriver.
C
STEP 2
Prepare the keyboard platform (B) by applying 2 foam pads (E) to the bottom surface as shown in the first image. Turn the keyboard platform (B)
upright and insert four threaded inserts (C1) into the top surface.
E
B
STEP 3
Apply four rubber feet (F) to the bottom of workstation (A) and remove plastic strap.
A
F
C1 C2
C1
B
CAUTION: Do Not engage the handle when
removing the plastic strap. Only engage the handle
when the product is in the upright position.
3
11/15/19 2:12 PM